← Back to portfolio

Kaida

Gallery

OVERALLS DESIGN

Textile elastic bands are sewn into the jumpsuit, so it sits on the body like a glove - tightly, and at the same time it fits almost any size within reasonable limits. Cushioning zones give a large margin at the waist and unload the fur from heavy loads. The "digitigrade" form of the suit is set by the light lining filled with padding polyester which is attached to Velcro, so the lining can be washed separately. This design is much more long-lasting and lighter than exoskeleton pads made of foam rubber. Also it compresses perfectly for storage, transportation, and does not tire with its weight when wearing a suit, especially when you sweat.

HEAD DESIGN

The base of the head is made of dense 1 cm thick polyethylene foam, with a steel, stainless wire frame. Unlike a foam rubber mask, this design has a smaller contact area with the head of the fursuiter, it is less hot inside, this material does not rot and absolutely does not absorb moisture.

TAIL DESIGN

The tail is made with a removable fur skin for easier washing. A very strong fastening for a regular belt is made of nylon tape and holds on to the base of the tail, so the skin of the tail will not tear if it is pulled.

FEETPAWS DESIGN

The feetpaws have a foam rubber base. The heel is hidden inside so as not to beat off the heel during prolonged wear. The foot is held with soft linings on the sides and despite the large size of the feetpaws they do not hang out (up to foot length of 32cm or 13"). The paws have soft claws, all made of fleece and filled with padding polyester. Paw pads are voluminous. Included with outdoor sandals from light foam rubber soles.

Dimensions

Not sure how to measure? How to measure